Infocus IN8606HD Uživatelský manuál

IN8606HD User’s Manual Top view—On-screen Display (OSD) buttons and LEDs 312 ITEM LABEL DESCRIPTION SEE PAGE1. Turns the projector On and Off Red

IN8606HD User’s Manual Rear view 12103456 7 91112131415168 ITEM LABEL DESCRIPTION SEE PAGE 1. AC IN Connect a POWER cable 11 2. 3D SYNC Connec

IN8606HD User’s Manual – 5 – DC12V Trigger Note:  To use this feature, you must plug in the connector before turn on/off the projector.  Screen cont

IN8606HD User’s Manual Bottom view 100.0mm146.0mm68.7mm 75.0mm175.0mm173.9mm40.8mm4.5mm(6.89inch)(3.94inch)(2.95inch)(0.18inch)(5.75inch)(2.70inch)(6.

IN8606HD User’s Manual Remote Control Parts 123456789101112131415 Important: 1. Avoid using the projector with bright fluorescent lighting turned on.

IN8606HD User’s Manual –8 – ITEM LABEL DESCRIPTION SEE PAGE: 1. Up Navigates up and changes settings in the OSD 2. Enter Changes settings in t

IN8606HD User’s Manual – 9 – Remote Control Operating Range The remote control uses infrared transmission to control the projector. It is not necessar

IN8606HD User’s Manual –10 – SETUP AND OPERATION Inserting the Remote Control Batteries 1. Remove the battery compartment cover by sliding the cover

IN8606HD User’s Manual Turning the projector on and off 1. Connect the power cord to the projector. Connect the other end to a wall outlet. The POW

IN8606HD User’s Manual 5. To turn the projector off, press the POWER button. When the “Power Off? Press Power again” message appears, press the POWER

Copyright This publication, including all photographs, illustrations and software, is protected under international copyright laws, with all rights r

IN8606HD User’s Manual Setting an Access Password (Security Lock) You can use the four arrow buttons on the remote to set a password and prevent unaut

IN8606HD User’s Manual 5. You can use the arrow buttons ▲▼◄► either on keypad or IR remote control for password entry. You can use any combination in

IN8606HD User’s Manual Adjusting the Projector Level Take note of the following when setting up the projector:  The projector table or stand should

IN8606HD User’s Manual Adjusting the Zoom, Focus and Keystone 1. Use the Image-zoom control (on the projector only) to resize the projected image an

IN8606HD User’s Manual – 17 – ON-SCREEN DISPLAY (OSD) MENU SETTINGS OSD Menu Controls The projector has an OSD that lets you make image adjustments an

IN8606HD User’s Manual Setting the OSD Language Set the OSD language to your preference before continuing. 1. Press the MENU button. Press the ◄► butt

IN8606HD User’s Manual OSD Menu Overview Use the following illustration to quickly find a setting or determine the range for a setting. – 19 –

IN8606HD User’s Manual –20 – Image Menu Attention ! When image options are changed, the Display Mode changes to User. Press the MENU button to open t

IN8606HD User’s Manual Computer Menu Press the MENU button to open the OSD menu. Press the ◄► buttons to move to the Image menu. Press the ▲▼ buttons

IN8606HD User’s Manual Advanced Features Press the Menu button to open the OSD menu. Press the ◄► buttons to move to the Image menu. Press the ▼▲ butt

IN8606HD User’s Manual –ii – Important Safety Information Important: It is strongly recommended that you read this section carefully before using the

IN8606HD User’s Manual White Balance Press the (Enter) or ► button to enter the White Balance sub menu. Press ▼▲ to move up and down in the White Ba

IN8606HD User’s Manual Color Manager Press the Menu button to open the OSD menu. Press the ◄► buttons to move to the Image menu. Press the ▼▲ buttons

IN8606HD User’s Manual Settings 1 Menu Press the MENU button to open the OSD menu. Press the ◄► buttons to move to the Settings 1 menu. Press the ▲▼

IN8606HD User’s Manual Audio Press the Menu button to open the OSD menu. Press the ◄► buttons to move to the Settings 1 menu. Press the ▼▲ buttons to

IN8606HD User’s Manual Advanced 1 Features Press the Menu button to open the OSD menu. Press the ◄► buttons to move to the Settings 1 menu. Press the

IN8606HD User’s Manual 3D Setting ITEM DESCRIPTION 3D Press the ◄► buttons to enter and select different 3D modes. 3D Sync Invert Press the ◄► butt

IN8606HD User’s Manual Advanced 2 Features Press the Menu button to open the OSD menu. Press the ◄► buttons to move to the Settings 1 menu. Press the

IN8606HD User’s Manual Settings 2 Menu Press the MENU button to open the OSD menu. Press the ◄► buttons to move to the Settings 2 menu. Press the ▲▼

IN8606HD User’s Manual Status Press the ▲▼ buttons to move up and down in the Settings 2 menu. Select the Status menu and press (Enter) or ► to enter

IN8606HD User’s Manual Advanced 1 Features Press the Menu button to open the OSD menu. Press the ◄► buttons to move to the Settings 2 menu. Press the

Preface Projector Installation Notice  Place the projector in a horizontal position The tilt angle of the projector should not exceed 15 degrees.

IN8606HD User’s Manual Lamp Hour Reset Please refer to Resetting the on page 38 to reset the lamp hour counter. – 33 –

IN8606HD User’s Manual Advanced 2 Features Press the Menu button to open the OSD menu. Press the ◄► buttons to move to the Settings 2 menu. Press the

IN8606HD User’s Manual Source Filter Press the ENTER button to enter the Source Filter sub menu. This sub menu allows you to enable and disable source

IN8606HD User’s Manual –36 – MAINTENANCE AND SECURITY Replacing the Projection Lamp The projection lamp should be replaced when it burns out. It shoul

IN8606HD User’s Manual 2. Remove the lamp compartment cover. 3. Remove the three screws from the lamp module. 4. Lift the module handle up. 5. Pu

IN8606HD User’s Manual Resetting the Lamp Timer After replacing the lamp, you should reset the lamp hour timer to zero. Refer to the following: 1. Pr

IN8606HD User’s Manual – 39 – Cleaning the Projector Cleaning the projector to remove dust and grime will help ensure trouble-free operation. Warning

IN8606HD User’s Manual Using the Cable Lock System and Security Bar Using the Cable Lock If you are concerned about security, attach the projector to

IN8606HD User’s Manual – 41 – TROUBLESHOOTING Common problems and solutions These guidelines provide tips to deal with problems you may encounter whil

IN8606HD User’s Manual –42 – LED Error Messages ERROR CODE MESSAGES POWER LED BLUE LAMP LED RED System initialization Flashing OFF Ready to power on (

IN8606HD User’s Manual Power Safety  Only use the supplied power cord.  Do not place anything on the power cord. Place the power cord where it wil

IN8606HD User’s Manual – 43 – Problem: The image is wider at the top or bottom (trapezoid effect) 1. Position the projector so it is as perpendicula

IN8606HD User’s Manual –44 – Audio Problems Problem: There is no sound 1. Adjust the volume on the remote control. 2. Adjust the volume of the audi

IN8606HD User’s Manual – 45 – HDMI Q & A Q. What is the difference between a “Standard” HDMI cable and a “High-Speed” HDMI cable? Recently, HDMI L

IN8606HD User’s Manual –46 – SPECIFICATIONS Specifications Model IN8606HD Display type 0.65 DMD 1080P, DC3,S600 with DDP4422 ASIC Resolution 1080p 192

IN8606HD User’s Manual – 47 – Projection Distance vs. Projection Size Projection Distance and Size Table IN8606HD IMAGE DIAGONAL （MM/INCH） IMAGE WIDT

IN8606HD User’s Manual –48 – Timing Mode Table SIGNAL RESOLUTIONH-SYNC ( KHZ ) V-SYNC( HZ ) COMPOSITES_VIDEO COMPONENT RGB (ANALOG) HDMI (DIGITAL)NTS

IN8606HD User’s Manual – 49 – SIGNAL RESOLUTIONH-SYNC ( KHZ ) V-SYNC( HZ ) COMPOSITES_VIDEO COMPONENT RGB (ANALOG) HDMI (DIGITAL)1280 x 1024 91.1 8

IN8606HD User’s Manual Projector Dimensions 264.1mm [10.40"]285.1mm [11.22"]130.4mm [5.13"]122.3mm [4.81"] –50 –

IN8606HD User’s Manual – 51 – REGULATORY COMPLIANCE FCC Warning This equipment has been tested and found to comply with the limits for a Class B digit

IN8606HD User’s Manual –52 – APPENDIX I Serial Communication The following table describes the serial communication configuration that should be used

Preface –v – Table of Contents GETTING STARTED...

IN8606HD User’s Manual – 53 – No Function Command RW Min Max Default Step Parameter 16V Color Temp TMP RW 0 2 Source Specific1 Valid only when

IN8606HD User’s Manual –54 – No Function Command RW Min Max Default Step Parameter 63V Language LAN RW 0 20 0 1 0:English 1:French 2:German 3

IN8606HD User’s Manual – 55 – No Function Command RW Min Max Default Step Parameter 117 Projector Low Power Hours LTE R 0 9999 Displays the

IN8606HD User’s Manual –vi – SPECIFICATIONS...

IN8606HD User’s Manual – 1 – GETTING STARTED Packing Checklist Carefully unpack the projector and check that the following items are included: DLP P

IN8606HD User’s Manual Views of Projector Parts Front-right View 12345 ITEM LABEL DESCRIPTION SEE PAGE 1. IR receiver Receive IR signal from rem