Infocus PRJ-LIFT-UNIV Instalační manuál stáhnout pdf

INSTALLATION INSTRUCTIONS

Instrucciones de instalación

Installationsanleitung

Instruções de Instalação

Istruzioni di installazione

Installatie-instructies

Instructions d´installation

This device complies with part 15 of the FCC rules. Operation is subject to the following 2 conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are

designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate

radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio or television

communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment to an outlet on a circuit other than that to which the receiver is connected

Consult the dealer or an experienced radio/TV technician for help

SL220

Suspended Ceiling Lift

1 2 3 4 5 6 ... 19 20

Shrnutí obsahu

Strany 1 - Suspended Ceiling Lift

INSTALLATION INSTRUCTIONSInstrucciones de instalaciónInstallationsanleitungInstruções de InstalaçãoIstruzioni di installazioneInstallatie-instructiesI

Strany 2 - : Failure to provide adequate

SL220 Installation Instructions10IMPORTANT ! : Select power cord (W or X) suitable forlocation. If neither of those cords are suitable for your locati

Strany 3 - TABLE OF CONTENTS

Installation Instructions SL22011Figure 145. While still pulling the projector cradle away from the sides ofthe SL220, slide front channels towards ba

Strany 4

SL220 Installation Instructions12Replacing Projector Cradle1. Slide front channels of projector cradle forward onto theSL220 bearings. (See Figure 18

Strany 5 - DIMENSIONS

Installation Instructions SL22013Adjustments1. Adjust projector left or right by loosening the wing nuts onthe SL220 cross bracket. (See Figure 22)2.

Strany 6 - PREPARING FOR INSTALLATION

SL220 Installation Instructions14CAUTION: KEEP SL220 OPEN WHILE PROJECTOR ISRUNNING OR IN COOLING MODE! Premature bulb failureor damage to electrical

Strany 7

Installation Instructions SL22015Fault ConditionIMPORTANT ! : If the SL220 control system sees a faultcondition it will stop the operation and a red l

Strany 8

SL220 Installation Instructions16RS485 InformationCommunication parameters as specified in ANSI TIA/EIA-485-A:Table 2: COMMAND STRINGS FOR SL-220•

Strany 9 - PREPARING THE SL220

Installation Instructions SL22017Remote Control CapabilitiesThe remote control has a range of 20-30ft (6-9m), and ispowered by 2 AAA batteries that ar

Strany 10

SL220 Installation Instructions18Table 4: WIRING TABLE

Strany 11

Installation Instructions SL22019

Strany 12 - Replacing Projector Cradle

SL220 Installation Instructions2DISCLAIMERMilestone AV Technologies, and its affiliated corporations andsubsidiaries (collectively, "Milestone&qu

Strany 13 - Connecting Control Wiring

SL220 Installation InstructionsChief Manufacturing, a products divisionof Milestone AV Technologies8820-002009 Rev022011 Milestone AV Technologies, a

Strany 14 - OPERATING MODES

Installation Instructions SL2203TABLE OF CONTENTSDISCLAIMER... 2TABLE OF CONTENTS...

Strany 15 - Fault Condition

Installation Instructions SL2204TOOLS REQUIRED FOR INSTALLATIONPARTSI/Mx1 A (1)[SL220 Lift] B (1)[SL220 Frame] C (4)[Vertical Bra

Strany 16

Installation Instructions SL2205LEGENDDIMENSIONSTighten FastenerApretar elemento de fijaciónBefestigungsteil festziehenApertar fixadorSerrare il fissa

Strany 17 - Normal Operating Mode

SL220 Installation Instructions6PREPARING FOR INSTALLATIONInstallation RequirementsThe SL220 has been designed to be mounted recessed into asuspended

Strany 18 - Table 4: WIRING TABLE

Installation Instructions SL2207Securing SL220 Frame to Ceiling Structure1. Examine ceiling structure (concrete, steel truss, or wood)above SL220 fram

Strany 19

SL220 Installation Instructions8Wood Ceiling StructureWARNING: Anchors must be installed into wood with aminimum thickness of 1-1/2" (38.1 mm) or

Strany 20

Installation Instructions SL2209WARNING: IMPROPER INSTALLATION CAN LEAD TOLIFT FALLING CAUSING SEVERE PERSONAL INJURY ORDAMAGE TO EQUIPMENT! It is the

Komentáře k této Příručce

Žádné komentáře

Infocus PRJ-LIFT-UNIV Instalační manuál

Procházejte online nebo si stáhněte Instalační manuál pro Příslušenství pro montáž na zeď a strop Infocus PRJ-LIFT-UNIV. Infocus Automated Projector Ceiling Lift Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce